Smith & Wesson has identified a condition that may exist in certain PPK and PPK/S pistols which may permit a round to be discharged without the trigger being pulled. When the manual safety is disengaged, Smith & Wesson's Product Engineering Group has determined that the possibility exists in certain firearms that lowering the hammer may cause a chambered round to fire.
This recall applies to all Walther PPK and PPK/S pistols manufactured by Smith & Wesson from March 21, 2002, until February 3, 2009. STOP USING YOUR PISTOL AND RETURN IT TO SMITH & WESSON AT ONCE. Any unintended discharge of a firearm has the potential for causing injury, and we ask that you stop using your pistol immediately.
To facilitate the repair of your pistol, please contact Smith & Wesson's customer service department to receive instructions for the return of your pistol to Smith & Wesson.
More information and serial numbers at the S&W Website:
|
| *
NOTICE* Ruger LCP owners.
Ruger, has just put out a recall out on ALL LCP's.
"How to determine if your pistol needs the retrofit: All LCP pistols bearing prefix “370” (that is, serial number 370-xxxxx) may be affected. Newly manufactured and retrofitted “370” prefix LCP pistols with the new hammer mechanism installed have been marked with a diamond in the flat portion of the slot just behind and below the hammer as show to the right. Going forward, new pistols will be marked with the serial number prefix “371” (serial number 371-xxxxx). Pistols with the “371” prefix are not affected."
LOOK BELOW FOR THIS PIC OF THE GUN
|
 |
| LCP RUGER RECALL |
|
|
|